outer boundary
英 [ˈaʊtə(r) ˈbaʊndri]
美 [ˈaʊtər ˈbaʊndri]
网络 外边界; 外部边界; 还可用边界线; 界线; 边界线
英英释义
noun
双语例句
- Taking wellbore storage and skin effect into account, this paper studied the flow distribution in homogenous reservoir model with constant pressure outer boundary under the condition of controlled bottom pressure.
针对外边界定压的均质储层模型，研究了在控制井底流动压力状态下考虑井筒储存和表皮效应的油气井产率的变化规律。 - Considering the border conditions of displacement and stress continuity in the adhesive interfaces and the outer boundary conditions, the solutions of all unknown coefficient functions were derived.
利用内粘连边界的位移、应力连续条件和最外层边界条件，求得了所有未知系数函数的解。 - For Dirichlet boundary conditions, our numerical experiments show that the magnetic field concentrates on the outer boundary;
数值模拟表明当柱中心使用Dirichlet边界条件时，磁场出现趋肤； - Under these circumstances, reconnection takes place along a wide equatorial belt, opening up nearly the entire outer boundary of the magnetosphere to the solar wind.
在这种情况下，磁力线重连会在赤道面上宽广的带状区域内发生，几乎把整个磁层外围边界都打开，放太阳风进来。 - The basic criterion of drawing the approximate outer boundary of pressure arch was proposed: basically the outer boundary distribution of pressure arch and the maximum principal stress vector distribution in the surrounding rock must be tended to the conformity.
提出了绘制压力拱的近似外边界的基本准则：压力拱的外边界分布须与围岩中最大主应力矢量分布基本上趋于一致。 - Using the Michell solution and the crack solution, the integral equation of a radial crack in a hollow cylinder reinforced on its outer boundary is derived.
本文结合使用Michell环形域级数解及单裂纹解，导出了外边界被加劲的空心圆柱的径向裂纹积分方程，进而分析了加劲薄膜对裂纹应力强度因子的影响。 - The outer boundary condition is infinite or half infinite large circular reservoir.
外边界条件：无限大、半无限大、圆形油藏。 - The conventional methods of iris preprocessing are based on the assumption that both the inner boundary and the outer boundary of an iris can be taken as circles, and segment the iris using the two circular borders.
传统的虹膜预处理方法基于虹膜的内外边界为圆的假设，用两个圆将虹膜从眼睛图像中分割出来；然而，圆形的边界并不能精确地将虹膜分割出来。 - Based on coupled heat transfer theory and finite element method ( FEM), outer boundary conditions between parts were transformed into inner boundary conditions of the component.
基于耦合传热理论和有限元方法，将零件间的外边界条件转变为零件的内边界条件，直接对零件进行耦合仿真计算。 - Then, the influence of outer boundary conditions and conductivity profiles of PML to its absorbing performance is synthetically discussed.
然后综合讨论了理想匹配层外边界条件和导率剖面对吸收性能的影响。